Will Call by Appointment Only
We ship Worldwide Daily!

Up Blown Injection Tunnel Ram Injection Single Butterfly Injection Fuel Log Diagrams Barrel Valve Leakdown Pertinent Specifications &  Poop Carb Linkage Instructions Fuel Pump Tech Spring Pressure Chart

How to Leak Down a Barrel Valve on Mechanical Fuel Injection

This short video will assist you in either setting up a barrel valve initially or after a service was necessary.
  1. Adjust Butterflies Air Gap
  2. Block Off all Injector Lines & Returns except for Hat Nozzles
  3. Connect Input of Leakdown Tester to Outlet of Compressor
    (Do not connect anything to OUTPUT of Tester yet)
  4. Set Regulator to read 0 on 2nd Gauge of Dual Tester or,
    Set Regulator to read 0 on Single Gauge
  5. Connect Tester to Inlet of Barrel Valve
  6. Read % Leakage on 2nd Gauge (or Single Gauge)
  7. Adjust Linkage Turnbuckle on Barrel Valve for Desired Leakage

 

Technical Diagrams for Plumbing your System:

 
-Blown Injector Hat Diagrams

-Tunnel Ram Injector Diagrams

 

 

Bottom Border

Phone: 562/945-7669
Email: sales@dragparts.com
"Our Ultimate Goal is Your Success"
Good Vibrations has Been Empowering Racers Since 1989

Performance Products | Pre-Owned Parts | Press Releases | Technical | Photo Gallery | Contact Us

We STOCK the following performance race products: Aeromotive, Billet Connection, The Blower Shop (TBS), Control Cable, Deist Safety, DJ Safety, Enderle Fuel Injection, FIE, IMI Hi-Torque, JAZ Products, Lucas Oil, Mallory Ignition, Milodon, Prolong, SCE Gaskets, System 1 Filters, Total Seal Rings, Wilwood and XRP Plumbing. Zoomie Headers & Waterman 

This site has been created & maintained by Good Vibrations Motorsports. All text and material are copyright 1989-2024 by Good Vibrations Motorsports. All logos and images are reserved.