Up • Search • Index • Performance Products • Pre-Owned Parts • Technical • Race Team • Contact Us
 Leakdown Instructions

Leak Down testers are designed for checking leakage on engine cylinders. Also are ideal for leaking barrel valves on fuel injection   Leakdown Tester

 
 Engine Cylinder Leakdown:

1) For most accurate results, engine should be up to operating temperture.

2) Remove all spark plugs.

3) Rotate crankshaft until piston being tested is at top dead center of compression stroke.

4) Screw the spark plug adaptor hose into spark plug hole making the sure the o-ring is seated properly.

5) Connect leakdown tester to a good source of compressed air, preferably a filtered and water trapped source.

6) Adjust the regulator on the leakdown tester so the the LEFT HAND GAUGE indicates 100 pounds.

7) Connect the spark plug adaptor hose to the coupler of the leakdown tester.

8) Read the leak down percentage on the RIGHT HAND GAUGE.

 

 

 

Toll Free: 800/576-7661
"Our Ultimate Goal is Your Success"
 • Up • Search • Index • Performance Products • Pre-Owned Parts • Technical • Race Team • Contact Us •

We STOCK the following performance race products: BDS Blower Drive Service, Bell, Control Cable, Deist Safety, DJ Safety, Enderle Fuel Injection, IMI Hi Torque Starters, Jaz Products, K&N Air Filters, Mallory Ignition, RCD Engineering, SCE Gaskets, Smiley Headers, System 1 Filters, Total Seal and Wilwood Engineering  

   This site has been created and is mantained by Good Vibrations. All text material from Good Vibrations is © Copyright 1998-2010, Good Vibrations. All logos and images are reserved.